Micro Regenerative Air Dryer 1.0mpa Heatless Freeze Drying Equipment

High Quality Heatless Regenerative Desiccant Air Dryer Adsorption Air Dryer Absorption Air Dryer

1, The operation parameters, remote start / stop control of the acquisition equipment, monitoring of the operation status and various fault information can be uploaded and realized;
2, Energy saving: multi-core drive can save more than 10% of the comprehensive energy consumption compared with the fixed cycle mode; the dew point energy-saving control can be selected, which can extend the adsorption time of a single tower and reduce the comprehensive energy consumption by more than 30% under the condition of load fluctuation;
3, Customized high performance adsorbent, designed 20% filling surplus;
4, High performance pneumatic valve, reliable performance, long service life;
5, Taiwan brand high pressure blower;
6, International brands such as Schneider of France are selected as electrical components.
7, 304 stainless steel control gas pipeline, beautiful and generous;
8, The special designed diverter has the advantages of high adsorbent utilization rate and small gas pressure loss;
9, High efficiency cooler designed by HTFs software;
10 ,Siemens PLC controller, Kunlun Tongtai 7-inch large screen touch screen, dynamic monitoring operation process;
11, The most comprehensive signal acquisition, monitoring and display, including: air inlet temperature, heater temperature, regeneration tail gas temperature, a / b tower pressure, blower pressure, dew point temperature (optional)

Main specialties

Energy-saving dew point sensor with standard configuration (medium and large series)

All function indicators are displayed.

Small size, light weight, convenient maintenance.

Heatless Adsorption Dryer Workflow

	1.Two towers drying in parallel Before start-up, the inlet and outlet valves of the left and right towers are always open, and compressed air passes through both towers to the point of use at the same time.
	2. The left tower is dried and the right tower is regenerated After the power is turned on, the right tower inlet / outlet valve is closed, the right tower regeneration inlet / exhaust valve is opened, and the compressed air flows through the left tower to be dried. The dry air passes through the orifice plate, and the right tower is regenerated after being throttled and expanded.At this time, the pressure of the right tower should be 0 kg. The compressed air containing moisture is released into the atmosphere through the right tower regeneration exhaust valve and muffler. left and right towers are always open, and compressed air passes through the two towers to the point of use simultaneously.
	3.Regeneration is over, ready to boost After 4 and a half minutes of regeneration, the right tower regeneration exhaust valve was closed, and the right tower began to boost pressure.
	4. The left tower is dry and the right tower is boosted The booster valve opens, and the pressure of the two towers slowly rises to equilibrium.After 5 minutes, the tower is changed to enter the next cycle.